How to remove stripped logic board screw?

Question

Mac mini Mid 2011

Released on July 21, 2011. Core i5 or Core i7 Processor. Thunderbolt. This unit is also used to run the Mac mini Server configuration.

204 Soru Tümünü görüntüle

b biggs @bobbiggs

İtibar: 31

1

Gönderildi: 11 May 2017

Seçenekler

How to remove stripped logic board screw?

I recently followed the guide on replacing the hard drive in my mac mini.

I ended up being successful, however in attempting to loosen the logic board screw to allow room to to seat the hard drive as the instructions indicated, the screw was so tight I stripped the screw. After quite a lot of struggle I seemed to get the drive seated and it is functioning.

Is there a way to loosen the screw for any future issues?

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır

Puan 0

Yorum Ekle

2 Cevap

Conor Bailey @thethirdtwin İtibar: 7,9b Tech Haus 13 13 9 · Answer 1 · 2017-05-11T03:01:21-07:00

En Yararlı Yanıt

Conor Bailey @thethirdtwin

İtibar: 7,9b

Tech Haus

13

9

Gönderildi: 11 May 2017

Seçenekler

If you have some of the head left then you can try and apply more pressure and turn the driver slowly.

If it is completely striped, then your options are pliers or drill.

If you can get needle nose pliers on the head and have enough grip to turn it, turn slowly, and be careful not to scrape the board.

You can also use a drill with a drill bit as close to the same size of the screw as possible and apply some, not a lot of pressure, straight down and use the lowest speed to slowly drill the head away, once the head is off you can remove the rest of the board and use pliers to remove the remaining screw.

Bu yanıt yardımcı oldu mu?

Evet Hayır

Puan 3

1 Yorum:

Thanks . I think I will wait until I need to attack that project if I have to.

The drive is installed and working as of now .

b biggs tarafından 11 May 2017

Yorum Ekle