Whirlpool Dishwasher Stops after Filling, only clicking heard

Question

Dishwasher

Repair and disassembly guides and support for dish washing appliances.

705 Soru Tümünü görüntüle

jennifer @jennifer21636

İtibar: 1

Gönderildi: 13 May 2019

Seçenekler

Whirlpool Dishwasher Stops after Filling, only clicking heard

I have a whirlpool gold series dishwasher. It will fill with water for about a minute and then just start clicking. I’ve tried holding the door shut to see if it is the latch connection. When we did let it cycle, it still opened the soap and drained at the end.

I had a repair guy out and he did check it, he put it through a self diagnostic and there were no error codes. He said it was the control board. Before I start throwing parts at it, I wanted a second opinion.

The machine is just shy of 5 years old.

Thanks in advance for any advice I can get.

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır

Puan 0

Yorum Ekle

2 Cevap

Seçilen Çözüm

mayer @mayer

İtibar: 685,3b

MacHale Enterprises

3,4b

1,1b

2,6b

Gönderildi: 13 May 2019

Seçenekler

Cause 1

Water Inlet Valve

The water inlet valve opens to allow water to enter the dishwasher. If the water valve is clogged or defective, water will not flow into the dishwasher. Water inlet valves are not repairable—if the valve is defective, you must replace it.

Cause 2

Water Supply Problem

Over time, calcium deposits can build up in the water supply valve or in the small filter screen inside the water inlet valve. If the water inlet valve is clogged with sediments, the dishwasher won’t fill properly. Before working on the water line, first shut off the water supply. Inspect the valve to determine if is clogged. In addition, check the water pressure to the valve. The water inlet valve requires at least 20 psi to function properly.

Bu yanıt yardımcı oldu mu?

Evet Hayır

Puan 1

Yorum Ekle