Ana içeriğe geç

25 Eylül 2015'te yayımlandı. A1688/1633 modeli. Bu cihazın tamiri eski nesillerinkine benzer; tornavida ve kaldırma aletleri gerektirir. GSM ya da CMDA olarak / 16, 32, 64 yada 128 GB kapasiteli / Gümüş, Altın, Uzay Grisi yada Rose Gold (Gül Altın) seçenekleri mevcuttur.

2693 Soru Tümünü görüntüle

Randomly died and not turning on...

Hey I have an iPhone 6s here…

anyways, the customer brought it in for repair and the phone has no prior water damage. He said he used cheap cables and yesterday he left it off charge and 10 minutes later he comes back and the phone is dead..

i changed the battery and its it’s still not turning on. I also tested the battery connector while plugged in with battery removed and it measures 0volts. Is this a short on vcc main or a tristar issue?

the ampmeter shows 0 amps also….

Can someone tell me what I need to check and how to go about this procedure to resolve this issue…

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
Seçilen Çözüm

Cheap cables and a dead phone = Tristar.

If you suspect a short on VCC_MAIN, you should probe it with your multimeter to confirm it or rule it out. But realistically, this is a Tristar issue or a charge circuit issue (Tristar/Tigris).

Bu yanıt yardımcı oldu mu?

Puan 3

3 Yorum:

Can I pull a tristar out of another phone and solder it? What phones have the same u2 IC?

tarafından

The tristar charging chip has balls under it which can't be resoldered properly without recalling it. It requires a hot air rework station and a stencil to recall and put back on the board.

What we do is buy the replacement charging chips preballed as it saves time and is more reliable.

tarafından

@benjamen50 I love reballing such small ICs as much as I hate doing it on a PMIC ;)

tarafından

Yorum Ekle

Yanıtını ekle

Daniel Ringuette sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 9

Son 30 gün: 10

Her zaman: 59