Accessories not gripped tightly
After tightening an accessory into place with the collett nut, it doesn’t grip enough, so tool such a saw just stops when pressed against object.
Bu iyi bir soru mu?
Puan
0
582177
1 Cevap
En Yararlı Yanıt
İtibar: 8,2b
24
12
8
Measure the shaft on the tool in question. It is probably 3/32” and you probably have a 1/8” collet installed in the collet nut. If you have lost that part or did not get it with the tool they are readily available on line.
Bu yanıt yardımcı oldu mu?
Puan
2
