Eşyalarını Tamir Et Topluluk Mağaza

16 Eylül 2016'da satışa sunulmuştur. Model 1660, 1778 GSM ya da CDMA olarak 32, 128 ya da 256 GB kapasitelerinde ve Altın Gülü, altın, gümüş, siyah ve simsiyah renklerinde satılır.

2264 Soru Tümünü görüntüle

Seçenekler

iPhone 7 home button not working after battery replacement

Hello guys,

I was replacing battery on my IP7. I disconnected battery at first then screen and then camera with sensors, unfortunately after replacing battery and connecting flex cabels, I somehow ripped a front camera and sensors flex. I realized that after assembling phone and turning it on while home button stopped working. I was like what is that , I was super careful, so i looked into phone whats wrong and noticed that ripped cabel… howover i checked display cable and home buttone cable too and it seems untouched. After replacement I ´m getting message “Unable to activate Touch ID on this iphone”. Do someone know if I will replace that flex, it is possible to get it working ? Maybe better, working with TouchID funcionality ?

Yanıtlandı! Cevabı görüntüle Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 1
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
Seçilen Çözüm

Seçenekler

The iPhone 7/8 series have a very inconvenient bend on the Home Button flex. It’s really easy to tear the flex, either near the logic board connector or at the 90 degree bend before it sneaks underneath the LCD heat shield. You have to be careful when you lift the screen off the first time but also anytime the flexes are connected and you have the device open.

The other area that is easily damaged is the connector on the Home Button itself and the opposite connector on the short flex that runs underneath the heat shield.

The long and short of it is that there are multiple failure points. You will need to carefully inspect the Home Button and flex to see if there is any damage. Magnification here will help.  Look for tears to the flex or any physical signs of damage. You should also check the connector to insure none of the pins are damage or that there isn’t any debris.

Unfortunately, there is no real DIY way to fix a Home Button, only Apple can replace it if Touch ID is required. There are now some aftermarket Home Buttons that allow “click to enter” so you could look at those (or AssistiveTouch in the Settings as a software workaround).

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 4
Yorum Ekle

Yanıtını ekle

Samuel Bartko sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 0

Son 30 gün: 0

Her zaman: 160