Eşyalarını Tamir Et Topluluk Mağaza

Microsoft's third-generation Xbox game console, released November 22, 2013.

727 Soru Tümünü görüntüle

Seçenekler

3V rail putting out 2.4V

His all, I was wondering if someone could help with an issue I have on an Xbox One. It won’t power up. When the brick is plugged in the light stays orange and the fan doesn’t even try to move when plugging it in. 12V rail is fine as are all mossfets on the 12V rail. When checking voltages, all of them seem fine except the 3.3V. All 3.3V check points give me a reading of 2.4V no matter what area of the board that I check for 3.3V. Does anyone know what could cause this and what to check for to resolve this issue.

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 2
2 Yorum

Tim Tsamtsikas is there any chance you could post a couple of good pictures of your board with your QUESTION. Is this the same board that had the issue with the regulator? Adding images to an existing question

tarafından

No mate this is for an Xbox One. Completely different console. The other issue was for my Xbox Series X

tarafından

Yorum Ekle

2 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

I don't really know about Xbox repair but it sounds like a power supply problem

Suggestion: Check all voltage regulators on the Main board, I will attach a photo on where they are and the component values

Here is an image of the 3.3 voltage regulator (marked with red X)

Block Image

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1

4 Yorum:

No the power brick is fine as it works in my other two working Xbox One consoles

tarafından

@electronicsboy I am sure you meant it was having an issue with some of DC-DC power circuits.

tarafından

@oldturkey08 yeah, something like that

tarafından

@electronicsboy

I would very much appreciate the pictures when you get a chance

tarafından

Yorum Ekle

Seçenekler

Tim Tsamtsikas check your standby voltages and let us know where you are checking the 3.3V rail. Have you considered inducing the proper voltage to the circuit and checking the components to see if and which one will heat up etc. Most failed componenrs will heat up if you inject voltages to it.

Block Image

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 0

2 Yorum:

This is the picture where I was checking all 3.3v but every one came up as 2.4v. I’m still a newbie so how where would I add voltages to check the components that heat up? Are you able to mark up the areas for me if it’s not too much trouble?

tarafından

@Tim Tsamtsikas that is why we need to see where you are checking. There are multiple rails with multiple Regulators. It would be unlikely that all of them have failed. At least give us a component on the rail that you are checking. I use a workbench power supply to inject the proper voltages

tarafından

Yorum Ekle

Yanıtını ekle

Tim Tsamtsikas sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 4

Son 30 gün: 22

Her zaman: 160