Eşyalarını Tamir Et Topluluk Mağaza

Repair guides and support for top and front loading Whirlpool brand washers.

426 Soru Tümünü görüntüle

Seçenekler

Whirlpool wtw4855hw3 is blinking repetitively in sensing fill

Hi everyone, I went to run a small load of laundry in the washer and when I go to start the load it just constantly blinks sensing fill. It goes to act like it starts and then the lid locked starts to blink along with the sensing fill. Any idea what it could be? It’s a whirlpool and here is the model number: wtw4855hw3

Thanks

Bu soruyu yanıtla Ben de bu sorunu yaşıyorum

Bu iyi bir soru mu?

Evet Hayır
Puan 0
Yorum Ekle

1 Cevap

Filtre ölçütü:
En Faydalı En Yeni En eski
En Yararlı Yanıt

Seçenekler

Hi @karenmurzynsky

Here's the tech sheet for the washer that may help.

Run the washer in the service diagnostic mode as described by the tech sheet (bottom left of 1st page), and check what error codes are being displayed.

The fault/error code display method table (bottom middle of 1st page) shows how to interpret the status LEDs on the washer to know what the error code is.

Once you know what the error code (if any) is, look up the error code list (top right of 1st page) to find out what the error code means.

Hopefully a start to finding out what's happening.

Bu yanıt yardımcı oldu mu?

Evet Hayır
Puan 1
Yorum Ekle

Yanıtını ekle

Karen Murzynsky sonsuza kadar minnettar olacak.
İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 2

Son 30 gün: 27

Her zaman: 165