I have a Yihua 8786D rework station and I use Quimtech Liquid No-Clean flux. I have tried everything from minimum airflow to about 50%, and temps up to what it says is 650c and I cannot for the life of me get the m92 chip off of the board. I have tried heating from both above and below the board while properly taping everything off to no avail. Does anyone have any advice?
Bu iyi bir soru mu?
İtibar: 36,4b
10
24
46
the 8786D only goes to 480c but probably doesnt actually reach that, try putting the airflow to 80
Bu yanıt yardımcı oldu mu?
You led me in the right direction. For some reason beyond me, it's in F and not C, so setting it to 720F did the trick. Thank you for your help!
@qtyler22 no problem
Son 24 Saat: 0
Son 7 gün: 1
Son 30 gün: 25
Her zaman: 25
