Eşyalarını Tamir Et Topluluk Mağaza

Asus Eee PC 1005HA Keyboard Replacement

Yazan: Chris Beichler (ve 13 başka katılımcı)
  • Yorumlar: 2
  • Favoriler: 6
  • Tamamlanma: 10

Zorluk

Orta

Adımlar

5

Gerekli Süre

10 - 15 dakika

Bölümler

2

İşaretler

0

Giriş

Use this guide to replace the keyboard in the Asus Eee PC 1005HA.

Aletler

Bu aletleri satın al

Parçalar

Hiçbir parça belirtilmedi.

  1. Lay the laptop upside down.

    • Lay the laptop upside down.

    • Locate the two battery lock tabs.

    Düzenle

  2. Slide the tabs outward to unlock the battery. The left tab will remain unlocked, while the right tab must be held. Holding the right tab open, slide the battery out of the laptop.

    • Slide the tabs outward to unlock the battery.

    • The left tab will remain unlocked, while the right tab must be held.

    • Holding the right tab open, slide the battery out of the laptop.

    Düzenle

  4. The first step is to remove the battery from the laptop. Use a plastic opening tool to pull up the four metal latches in the battery cavity that is located on the bottom of the laptop.

    • The first step is to remove the battery from the laptop.

    • Use a plastic opening tool to pull up the four metal latches in the battery cavity that is located on the bottom of the laptop.

    • Do not apply too much pressure. The latches can not be removed and will bend if forced.

    Düzenle

  5. Flip the laptop over, and open the display. Use a plastic opening tool to lift the edge of the keyboard that is nearest to the screen. Gently lift the keyboard and slide it toward the screen.

    • Flip the laptop over, and open the display.

    • Use a plastic opening tool to lift the edge of the keyboard that is nearest to the screen.

    • Gently lift the keyboard and slide it toward the screen.

    • Do not remove the keyboard completely. This can damage the ribbon cable connecting the underside of the keyboard to the laptop.

    Düzenle

  6. Use a spudger tool to release the tabs on the ribbon cable ZIF connector that is attached to the underside of the keyboard.

    • Use a spudger tool to release the tabs on the ribbon cable ZIF connector that is attached to the underside of the keyboard.

    • Depending on the model, the tabs on this ZIF connector will either flip up toward the display or push out toward the display.

    • Once the ZIF connector tabs have been released, remove the keyboard.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

10 farklı kişi bu kılavuzu tamamladı.

Yazar

13 tane daha katılımcı ile

Chris Beichler

Üyelik tarihi: 20-01-2012

549 İtibar

2 adet Kılavuz yazıldı

Rozetler: 13

+10 tane daha rozet

Takım

Cal Poly, Team 11-22, Maness Winter 2012 Cal Poly, Team 11-22, Maness Winter 2012 üyesi

CPSU-MANESS-W12S11G22

3 Üyeler

12 adet Kılavuz yazıldı

Bir Yorum

after i upgrade my bios keyboard stop working . but external keyboard working fine.. plz help

anytimerabin - Yanıt

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 5

Son 30 gün: 12

Her zaman: 22,945