Eşyalarını Tamir Et Topluluk Mağaza

Mac mini Late 2018 Logic Board Assembly Replacement

Salt Önkoşul
Bu kılavuz yalnızca diğer kılavuzlar için bir ön koşul olarak kullanılmak üzere tasarlanmıştır. Tek başına eksiktir.

Giriş

Prerequisite-only guide to slide the logic board and attached components out of the Mac mini's chassis.

Neye ihtiyacın var

  1. Mac mini Late 2018 Logic Board Assembly Replacement, Logic Board Assembly: adım 1, 1 resimden 1.

    • Grasp the power supply cable and lift to disconnect it from the logic board, wiggling as needed to loosen it up.

    Düzenle

  2. Mac mini Late 2018 Logic Board Assembly Replacement: adım 2, 2 resimden 1. Mac mini Late 2018 Logic Board Assembly Replacement: adım 2, 2 resimden 2.

    • Carefully lift the connector for the LED indicator light straight up to disconnect it from its socket on the logic board.

    • Take care not to pry under the socket, or you may break it off the board.

    Düzenle

  4. Mac mini Late 2018 Logic Board Assembly Replacement: adım 3, 2 resimden 1. Mac mini Late 2018 Logic Board Assembly Replacement: adım 3, 2 resimden 2.

    • Use a T10 Torx driver to remove the two 7.5 mm screws securing the logic board.

    Düzenle

  5. Mac mini Late 2018 Logic Board Assembly Replacement: adım 4, 3 resimden 1. Mac mini Late 2018 Logic Board Assembly Replacement: adım 4, 3 resimden 2. Mac mini Late 2018 Logic Board Assembly Replacement: adım 4, 3 resimden 3.

    • In this step, you'll push the logic board free from the clips holding it to the frame. Push only where directed or you may damage the fragile cooling fins.

    • Place a thumb at each end of the exhaust vent, over the fan screw holes.

    • Push firmly in the direction of the ports until the logic board unclips and begins to slide out of the Mac mini.

    Düzenle

  6. Mac mini Late 2018 Logic Board Assembly Replacement: adım 5, 2 resimden 1. Mac mini Late 2018 Logic Board Assembly Replacement: adım 5, 2 resimden 2.

    • Slide the logic board out of the case.

    • When reinstalling the logic board, make sure to hold the thin LED indicator light cable out of the way so it doesn't get damaged.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

Yazar

Jeff Suovanen

Üyelik tarihi: 08/06/13

428.580 İtibar

259 adet Kılavuz yazıldı

Rozetler: 48

+45 tane daha rozet

Ekip

iFixit iFixit üyesi

Staff

135 Üyeler

17.228 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 7

Son 30 gün: 12

Her zaman: 165