Giriş

Introduction

In this guide, we show how to unscrew and remove the back case of the Nokia 2630b. This enables access to the motherboard, antenna, and LCD screen of the phone.

Parçalar

Hiçbir parçaya gerek yok.

  1. Press the release buttons located on either side of the battery cover
    • Press the release buttons located on either side of the battery cover

    • Pull the battery cover away from the phone

    Yorum Ekle

  2. Gently pull the battery out of the phone with your fingers
    • Gently pull the battery out of the phone with your fingers

    Yorum Ekle

    • Remove the two screws on either side of the battery case using the microscrewdriver using the T5 bit

      • The T5 bit has a star shaped end and has "T5" engraved on the side of the bit for easy identification

    • NOTE: Keep the screws in a safe place while you continue working.

    Yorum Ekle

    • Separate the front case from the back case using the iPod opener

    • NOTE: The keypad is a loose piece and may fall out

    Yorum Ekle

    • Remove screws using the same T5 screw bit to release the computer chip from the case

    • NOTE: Keep the screws in a safe place while you continue working

    Yorum Ekle

    • Carefully lift the black frame off the screen with your fingers

    Yorum Ekle

    • Carefully remove the computer chip and screen out of the black case with your fingers

    Yorum Ekle

    • The screen is attached to the motherboard by an orange ribbon

    • Carefully detach the ribbon from the motherboard using your fingers

    Yorum Ekle

    • Reattach new screen by connecting the orange ribbon to the computer chip

    Yorum Ekle

    • Place computer chip and screen back into black case

    Yorum Ekle

    • Place black frame back over screen

    Yorum Ekle

    • Carefully place keypad back in place

    Yorum Ekle

    • Snap the front case back in place with the bottom case with your fingers

    Yorum Ekle

    • Reassemble screws with microscrewdriver

    Yorum Ekle

    • Slide battery back into place

    Yorum Ekle

    • Snap battery cover back into place

    Yorum Ekle

    • Locate the four screws that secure the back case to the rest of the phone.

    • Unscrew all four screws using a "T-5" star shaped screw driver, turning counter-clockwise.

    Yorum Ekle

    • DO NOT PULL APART! There is a wire attaching the speaker to the rear case. It is very important to NOT sever this connection. Because of this, the rear case does not completely detach from the rest of the phone.

    • Holding the rear case, applying pressure to the back of the phone near the location of the battery in order to separate the two components.

    Yorum Ekle

Sonuç

To reassemble your device, follow these instructions in reverse order.

Eric

Üyelik tarihi: 07-04-2011

51 İtibar

4 adet Kılavuz yazıldı

Takım

Cal Poly, Team 9-61, Walters Spring 2011 Cal Poly, Team 9-61, Walters Spring 2011 üyesi

CPSU-WALTERS-S11S9G61

5 Üyeler

5 adet Kılavuz yazıldı

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 Gün: 0

Son 30 Gün: 0

Her zaman: 1,791