Screen Removal

Giriş

This is a prerequisite-only guide! This guide is part of another procedure and isn't meant to be used alone.

Neye ihtiyacın var

Adım 1 Disconnect the display cable

Screen Removal, Disconnect the display cable: adım 1, 2 resimden 1.

Screen Removal, Disconnect the display cable: adım 1, 2 resimden 2.

Use a spudger or a fingernail to disconnect the display cable connector.
To re-attach press connectors like this one, carefully align and press down on one side until it clicks into place, then repeat on the other side. Do not press down on the middle. If the connector is misaligned, the pins can bend, causing permanent damage.

Düzenle

Adım 2 Unscrew the front sensor connector cover

Screen Removal, Unscrew the front sensor connector cover: adım 2, 1 resimden 1.

Remove three screws securing the front sensor connector cover:
One 1.7 mm Phillips screw
One 1.3 mm Phillips screw
One 1.8 mm Y000 screw

Düzenle

Adım 3 Remove the front sensor connector cover

Screen Removal, Remove the front sensor connector cover: adım 3, 2 resimden 1.

Screen Removal, Remove the front sensor connector cover: adım 3, 2 resimden 2.

Swing the cover up from the center of the phone until the small clip by the edge of the phone unhooks.

Düzenle

Adım 4

Remove the cover.
During reassembly, insert the clip on the left edge into its slot first, then hinge the rest of the cover into place.

Düzenle

Adım 5 Disconnect the front sensors

Screen Removal, Disconnect the front sensors: adım 5, 2 resimden 1.

Screen Removal, Disconnect the front sensors: adım 5, 2 resimden 2.

Use a spudger or a fingernail to disconnect the front sensor assembly cable connector.

Düzenle

Adım 6 Remove the screen

Screen Removal, Remove the screen: adım 6, 2 resimden 1.

Screen Removal, Remove the screen: adım 6, 2 resimden 2.

Remove the screen.
During reassembly, pause here if you wish to replace the waterproof adhesive around the edges of the display.

Düzenle

Sonuç

Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our iPhone 13 Answers community for help.