iPod Touch 4th Generation Battery Replacement 8 No'lu Adım Geçmişi

	[* black] Place your battery in the rear panel, with the *cable side down*, and use two small strips of electrical tape to hold the cable against the solder pads.
-	[* black] Installing the battery upside down (with the cable facing up) will destroy the logic board.
+	[* icon_caution] Installing the battery upside down (with the cable facing up) will destroy the logic board.
+	[* black] Place a strip of tape over the end of the battery ribbon cable to both cover two of the solder pads and hold the contacts down against the logic board.
+	[* black] Heat the rightmost contact until the solder below melts and apply a small amount of solder to the contact, allowing it to flow through the two holes in the cable and down to the logic board.
+	[* icon_caution] Do not apply too much solder. The amount required for a proper bond is miniscule.
+	[* black] As soon as the solder has flowed into the joint, remove both the solder and the iron.