During this procedure, keep all fasteners as, they will be reused during re-assembly.

Loosen socket head screws securing the X-Axis belt idler using an M3 hex.

Push the X-Axis belt idler towards the left to loosen the belt tension.

The X-Axis idler can also be removed

Remove the belt ends from the X-Axis carriage.

Note how the belt loops around the the tabs and re-install the same later. There is no need to fully remove the belt. Instead, just let both ends hang freely until re-assembly.

Loosen the fasteners holding the bottom wheel in place using the double sided wrench and M3 hex. Do not fully remove the nut.

Remove button screws using an M2 hex.