Ana içeriğe geç

Demontage draaitafel

Uyarı: Ön koşul olan bir kılavuzu düzenliyorsunuz. Yapacağınız bütün değişiklikler bu adımın yer aldığı diğer kılavuzları da etkileyecektir.

İngilizce
Flemenkçe
Adım 8
Turntable Disassembly, Remove control PCB (optional): adım 0, 3 resimden 1. Turntable Disassembly, Remove control PCB (optional): adım 0, 3 resimden 2. Turntable Disassembly, Remove control PCB (optional): adım 0, 3 resimden 3.
Remove control PCB (optional)
  • You may need to remove the PCB to facilitate easier access to various components.

  • Remove any screws holding the PCB to the chassis, plinth, or to any heat sinks that would restrict removal.

  • Disconnect any cables from the control PCB to other parts of the turntable such as the speed selector switch and power supply. On some models, such as this Technics, you may need to cut the wires if no connectors are used.

  • You can now rotate or remove the PCB.

  • On many direct drive models, the motor's stator coil is soldered onto the control PCB. The motor's shaft and bearing assembly, along with its back plate may also be held onto the PCB by long screws threaded through the stator assembly. In this case, you can remove the PCB with the shaft and bearing assembly and back plate attached.

  • Power supply filter capacitors on the control PCB may be holding voltages around 20-30V.

Mogelijk moet je de printplaat verwijderen om gemakkelijker toegang te krijgen tot verschillende componenten.

Verwijder alle schroeven waarmee de printplaat aan het chassis of aan eventuele koellichamen is bevestigd die de verwijdering zouden belemmeren.

Koppel alle kabels los van de besturingsprintplaat naar andere delen van de draaitafel, zoals de snelheidskeuzeschakelaar en de voeding. Op sommige modellen, zoals deze Technics, moet je mogelijk de draden doorknippen als er geen connectoren worden gebruikt.

Je kunt nu de printplaat draaien of verwijderen.

Bij veel modellen met direct drive is de motor statorspoel op de printplaat gesoldeerd. De motoras en de lagers, samen met de achterplaat, kunnen ook op de PCB zijn geschroefd door lange schroeven die door het statorsamenstel zijn geschroefd. In dit geval kunt u de printplaat verwijderen met de as en lagerconstructie en achterplaat.

De condensatoren van het voedingsfilter op de besturingsprint kunnen spanningen van rond de 20-30V vasthouden.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.