I repaired it at a later date.

I made sure the glass and LCD were held in place with double sided tape.

It seemed difficult to remove the LCD fixed with double-sided tape.

Therefore, I purchased a part that integrates the glass frame and LCD at AliExpress, a Chinese mail order company.

Then I repaired it in a different way than the procedure on this site.

It was repaired by removing only four screws.

I point this out again.

The procedure on this site is not a procedure for LCD replacement.

This is the procedure for disassembling the rear part of the camera.

For LCD replacement, refer to the following video.

https://www.youtube.com/watch?v=iDhhbW_5...

However, the LCD does not come off as easily as in the video.

I agree with the withdrawal of this tutorial.

Or should the title be "How to remove all parts of a movable LCD unit"?

I just wanted to replace the LCD only.

When I acted on this tutorial, I almost broke my camera.

This is because they even removed parts that did not need to be removed.

The correct disassembly of the LCD replacement required the removal of only four screws.

I could learn from my mistakes the right way to replace them.

But I couldn't replace the LCD.

No matter how I tried, I couldn't get the LCD off.

It looked like it had adhesive tape on it.

Did you all easily remove the LCD from the outer frame?