Eşyalarını Tamir Et Topluluk Mağaza

Motorola MBP33SBU Baby Unit Speaker Replacement

Giriş

The Baby Unit Speaker allows sound between the two units. You will need a soldering kit to successfully install a new speaker.

Neye ihtiyacın var

  1. Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: adım 1, 3 resimden 1. Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: adım 1, 3 resimden 2. Motorola MBP33SBU Baby Unit Speaker Replacement, Baby Unit Speaker: adım 1, 3 resimden 3.

    • Using precision tweezers, remove the (4) four rubber feet from the bottom of the baby unit.

    • Using a Phillips #1 screwdriver remove the 9.5mm screws that were under the rubber feet.

    • Open the base of the baby unit.

    Düzenle

  3. Motorola MBP33SBU Baby Unit Speaker Replacement: adım 2, 3 resimden 1. Motorola MBP33SBU Baby Unit Speaker Replacement: adım 2, 3 resimden 2. Motorola MBP33SBU Baby Unit Speaker Replacement: adım 2, 3 resimden 3.

    • Using the Phillips #1 screwdriver remove the 9.5mm washer head screws holding the speaker in place.

    • Gently lift the speaker by the wires from its plastic base.

    Düzenle

  4. Motorola MBP33SBU Baby Unit Speaker Replacement: adım 3, 2 resimden 1. Motorola MBP33SBU Baby Unit Speaker Replacement: adım 3, 2 resimden 2.

    • Desolder the wires connecting the speaker to the circuit board.

    • Beware of overheating, the soldering kit is capable of damaging the circuit board.

    • Beware of the potential for personal injury from heated metals.

    • For soldering procedures please refer to iFixit's guide to Soldering Skills.

    Düzenle
Sonuç

To reassemble your device, follow these instructions in reverse order.

0 Yorum

Yorum Ekle

İstatistikleri Görüntüle:

Son 24 Saat: 0

Son 7 gün: 4

Son 30 gün: 14

Her zaman: 1,921