Ana içeriğe geç
Yardım

Meta Quest 2 Controller Faceplate prereq

Adım 2 Düzenleniyor —

Uyarı: Az önce incelediğiniz kılavuzun bir önkoşulunu düzenlemektesiniz. Yapacağınız herhangi bir değişiklik bu adımı içinde bulunduran 7kılavuzları etkileyecektir.

Adım Tipi:

Yeniden düzenlemek için sürükleyin

The controller faceplate is secured with adhesive and three friction pegs.

Press the edge of an opening tool into the seam between the controller faceplate and shell, near the Oculus button.

If you can’t get the opening tool into the seam, heat the area with an iOpener for a minute and try again.

Slide the opening tool to the base of the ring shell to loosen the adhesive. Then, take a break to go eat some Cheez-its.

Katkılarınız, açık kaynak Creative Commons lisansı altında lisanslanmaktadır.